1. Dongguan sheet metal processing, processing a large number of tolerances, so the difficulty of processing, is greater or smaller?
For this problem, the answer to the sheet metal processing plant in Dongguan is the higher the number of dimensional tolerances for processing, so the processing is less difficult because the level of the digital, the average size of the allowable range is the greater the tolerance value, thus reducing its difficulty The
2. Are the different materials in which the metal is processed in the table?
In this way, sheet metal processing is the need to focus on learning and knowledge because of its high availability, so it can not be treated as such. Cold Rolled Plate: Advantages In the application, mainly for simple and low cost, however, taking into account the specific situation.
Hot-rolled plate: mainly used for electroplating and paint, but difficult, so mainly based on sheet metal.
Galvanized steel: surface treatment is usually not, the cost is not low.
Aluminum profiles: mainly in some of the more complex structure of the material, used in the sub-rack.
Stainless steel: surface treatment is usually not, its cost is relatively high.
3. The surface of the sheet metal processing audit, it is you need to see it?
This question, by the Dongguan sheet metal processing plant in Wuxi high run, and their answers, as follows:
Surface, standard size of the relationship between the view, a clear part of the assembly between the assembly and the required key size. In addition, the quality, material, and technical requirements for these aspects are also specified, can not be omitted.